[[File:Networking rut configuration 1 wire wiring example v3.jpg|border|class=tlt-border]]
[[File:Networking rut configuration 1 wire wiring example v3.jpg|border|class=tlt-border]]
Line 98:
Line 100:
[[File:Networking trb141 configuration 1 wire cli commands test v1.png|border|class=tlt-border|1100px]]
[[File:Networking trb141 configuration 1 wire cli commands test v1.png|border|class=tlt-border|1100px]]
+
+
==Connecting Multiple 1-Wire Sensors with TRB141==
+
+
The configuration for connecting multiple 1-wire sensors is the same as above.
+
There’s no restriction or limit on the number of sensors that can be connected to TRB141. However, there’s a limit on how many sensors can be read every second which is up to 75 sensors only.
+
+
===DS18B20 connection===
+
+
The wiring image is a similar scheme that we used as our guide for connecting multiple 1-Wire sensors on the TRB141.
[[File:Networking trb1 configuration multi 1wire via breadboard v1.png|border|class=tlt-border|500px]]
+
+
==Output==
+
Enable the 'ioman.gpio.onewire' service. You can configure this by following the instructions above regarding [[TRB141_1-Wire_Setup/Configuration#1-Wire_activation_commands|1-Wire activation commands]].
+
+
We should be able to see all the 1-wire sensor directories and read their values accordingly.