Line 1: |
Line 1: |
− | <p style="color:red">The information in this page is updated in accordance with firmware version '''[https://wiki.teltonika-networks.com/view/FW_%26_SDK_Downloads 00.07.03.3]'''. | + | <p style="color:red">The information in this page is updated in accordance with firmware version '''[https://wiki.teltonika-networks.com/view/FW_%26_SDK_Downloads 00.07.08]'''. |
| | | |
| ==Summary== | | ==Summary== |
Line 20: |
Line 20: |
| * Press '''Add''' | | * Press '''Add''' |
| | | |
− | [[File:Modbusupdategateway1.png|1000px|border|class=tlt-border]] | + | [[File:RutOS_RUT_Modbus_Gateway_7.8_add_instnace.png|1000px|border|class=tlt-border]] |
| | | |
| A new window will open, where the device should be configured according to these steps: | | A new window will open, where the device should be configured according to these steps: |
Line 27: |
Line 27: |
| * '''Listening IP''' – IP interface on which you are listening for incoming connections (input 0.0.0.0 to listen on any IP address) | | * '''Listening IP''' – IP interface on which you are listening for incoming connections (input 0.0.0.0 to listen on any IP address) |
| * '''Port''' – Port number for Modbus gateway (default port is 502) | | * '''Port''' – Port number for Modbus gateway (default port is 502) |
− | * '''Slave ID''' configuration type – User defined or obtained from TCP | + | * '''Server ID''' – preconfigured Server ID number |
− | * '''Slave ID''' – preconfigured Slave ID number
| |
| | | |
| You may need to change configuration depending on your needs, just make sure that identical settings are set here and in RTU simulator: Baud rate, data bits, parity, stop bits, flow control. | | You may need to change configuration depending on your needs, just make sure that identical settings are set here and in RTU simulator: Baud rate, data bits, parity, stop bits, flow control. |
| | | |
− | [[File:Navigateandenable.png|700px|border|class=tlt-border]] | + | [[File:RutOS_RUT_Modbus_Gateway_7.8_instance_config.png|700px|border|class=tlt-border]] |
| | | |
| In IP filter options on the bottom of the page, add IP addresses that will be allowed to reach your Modbus gateway (input 0.0.0.0/0 to allow any IP address). | | In IP filter options on the bottom of the page, add IP addresses that will be allowed to reach your Modbus gateway (input 0.0.0.0/0 to allow any IP address). |
| | | |
− | [[File:Ipfilter1.png|border|class=tlt-border]] | + | [[File:RutOS_RUT_Modbus_Gateway_7.8_instance_ip_filter.png|border|class=tlt-border]] |
| | | |
| After finishing the configuration, press '''Save & Apply'''. With a setup like this, you will be able to send data from Modbus TCP to Modbus RTU. | | After finishing the configuration, press '''Save & Apply'''. With a setup like this, you will be able to send data from Modbus TCP to Modbus RTU. |