Jump to content

Template:Networking trb2xx manual ethernet port leds: Difference between revisions

No edit summary
 
(5 intermediate revisions by the same user not shown)
Line 1: Line 1:
==Ethernet port LEDs==
==Ethernet port LEDs==


The Ethernet port LEDs are located on the gateway front panel, in the corners of Ethernet port:
The Ethernet port LEDs are located on the gateway front panel, in both upper corners on Ethernet port:


[[File:{{{file_eth_led}}}|{{{size_eth}}}px]]
[[File:{{{file_eth_led}}}|{{{size_eth}}}px]]
Line 25: Line 25:
     </tr>
     </tr>
     <tr>
     <tr>
         <td><span style="color: orange><b>LED</b></span> gradually fades in and out</td>
         <td><span style="color: orange><b>LED</b></span> blinking fast simultaneously with <b>connection</b> and <b>signal strength</b> LEDs</td>
        <td>Router is in the web recovery menu state<span class="asterisk">*</span></td>
         <td>Router is in the bootloader menu state<span class="asterisk">*</span></td>
    </tr>
    <tr>
        <td><span style="color: orange><b>LED</b></span> always ON (with or without cable connected)</td>
         <td>Router is in bootloader mode<span class="asterisk">**</span></td>
     </tr>
     </tr>
</table>
</table>


<span class="asterisk">*</span> The <b>web recovery menu</b> is a special router state from which certain upgrades can be performed. For more information on the web recovery menu, click [[Bootloader menu|here]]
<span class="asterisk">*</span> The <b>bootloader  menu</b> is a special router state from which certain upgrades can be performed. For more information on the bootloader  menu, click [[Bootloader menu|here]]
 
<span class="asterisk">**</span> <b>Bootloader mode</b> is only used for factory servicing, cycle gateway power without pressing any button and gateway should boot up normally. If gateway still enters bootloader mode again, contact your supplier or Teltonika support in [https://community.teltonika-networks.com  crowd support forum] for help