Line 22: |
Line 22: |
| {{#ifeq:{{{name}}}|RUT955| | | {{#ifeq:{{{name}}}|RUT955| |
| ==={{{name}}} disclaimer=== | | ==={{{name}}} disclaimer=== |
− | | + | ---- |
| <span style="color:red"><b>Note: </b></span>Due to hardware limitations, {{{name}}} devices do not support firmware flashing while an SD card is inserted into the device. To successfully perform a firmware upgrade, it is required to remove the memory card first. Otherwise there is a high risk of data and configuration loss. | | <span style="color:red"><b>Note: </b></span>Due to hardware limitations, {{{name}}} devices do not support firmware flashing while an SD card is inserted into the device. To successfully perform a firmware upgrade, it is required to remove the memory card first. Otherwise there is a high risk of data and configuration loss. |
| |}} | | |}} |
Line 111: |
Line 111: |
| <li>Run commands <code>opkg update</code> and <code>opkg install e2fsprogs</code> to download required tools.</li> | | <li>Run commands <code>opkg update</code> and <code>opkg install e2fsprogs</code> to download required tools.</li> |
| <li>Unmount the SD card with command <code>umount /dev/mmcblk0p1</code></li> | | <li>Unmount the SD card with command <code>umount /dev/mmcblk0p1</code></li> |
− | <li>Start formatting with command <code>mkfs.ext<b>X</b> /devmmcblk0p1</code> where X is either 2 (for ext2 format), 3 (for ext3 format) or 4 (for ext4 format).</li> | + | <li>Start formatting with command <code>mkfs.ext<b>X</b> /dev/mmcblk0p1</code> where X is either 2 (for ext2 format), 3 (for ext3 format) or 4 (for ext4 format).</li> |
| <li>A successful format procedure should look like this:</li> | | <li>A successful format procedure should look like this:</li> |
| <code>root@Teltonika-RUT955:~# mkfs.ext2 /dev/mmcblk0p1</br> | | <code>root@Teltonika-RUT955:~# mkfs.ext2 /dev/mmcblk0p1</br> |
Line 131: |
Line 131: |
| | | |
| <b>Note: </b> The <i>Writing inode tables</i> section might take a long time depending on the size of your SD card (10+ minutes with 64GB SD). | | <b>Note: </b> The <i>Writing inode tables</i> section might take a long time depending on the size of your SD card (10+ minutes with 64GB SD). |
| + | |
| + | |
| + | [[Category:{{{name}}} Manual]] |