Line 4: |
Line 4: |
| | | |
| * 1st option - the device turns on with the ignition and turns off when the ignition goes off. | | * 1st option - the device turns on with the ignition and turns off when the ignition goes off. |
− | * 2nd option - the device turns on with the ignition and stays on for some time, even if the ignition is turned off. | + | * 2nd option - the device turns on with the ignition and '''stays on for some time''', even if the ignition is turned off. |
| | | |
| This example will use the '''4-pin connector''', available on most of the Teltonika networking devices: | | This example will use the '''4-pin connector''', available on most of the Teltonika networking devices: |
Line 66: |
Line 66: |
| ---- | | ---- |
| * Navigate to Actions tab. | | * Navigate to Actions tab. |
− | * In the '''Add new instance''' section, input name (delayoff in this example) for action and in '''Type''' select '''Output''', press '''Add'''. | + | * In the '''Add new instance''' section, input name ('''delayoff''' in this example) for action and in '''Type''' select '''Output''', press '''Add'''. |
| | | |
| [[File:Addnewinstance.png|border|class=tlt-border]] | | [[File:Addnewinstance.png|border|class=tlt-border]] |
Line 90: |
Line 90: |
| | | |
| * Press '''Enable''' to enable the instance. | | * Press '''Enable''' to enable the instance. |
− | * Trigger interval – 1 (you could input a higher value, for example, if you are connecting to '''ACC''' and it turns off for a second when starting the vehicle - it would allow the Output Pin state remain static in the starting moment). | + | * Trigger interval – 1 (you could input a higher value, for example, if you are connecting to '''ACC''' and input signal goes off for a second when starting the vehicle - it would allow the Output Pin state remain static in the starting moment). |
| * Trigger – Falling (reacts when Ignition state goes from On to Off). | | * Trigger – Falling (reacts when Ignition state goes from On to Off). |
| * Add actions – select the action which you‘ve created previously ('''delayoff''' in this example). | | * Add actions – select the action which you‘ve created previously ('''delayoff''' in this example). |
Line 96: |
Line 96: |
| | | |
| [[File:Jugglerinstance.png|border|class=tlt-border]] | | [[File:Jugglerinstance.png|border|class=tlt-border]] |
| + | |
| + | With that, the configuration is finished. The device will stay on for as long as '''Execution delay''' value is set. |