Template:Networking tsw1xx manual powering options
Revision as of 10:30, 7 February 2023 by Gytispieze (talk | contribs)
This chapter contains information on powering options supported by {{{name}}} switch.
The switch has a pin power socket and can be powered by a VDC power supply unit (PSU). Refer to the image below for the power socket's pinout information:
Power socket
{{Template: Networking_{{{series}}}_manual_power_socket_pinout | name = {{{name}}} }}
{{#switch:{{{name}}} | TSW100|TSW101= ==Disclaimer: {{{name}}} and Passive PoE devices==
There are a couple of options to stay safe when using {{{name}}} Active PoE with devices that only support Passive PoE:
- Connect {{{name}}} and Passive PoE device only via non-PoE Ethernet ports (for example, do not use {{{name}}} PoE ports with LAN1 ports on Teltonika devices).
- If there is a need to use LAN1 port on the end device, make sure that {{{name}}} and the end device are powered from different voltage sources (for example, power both devices from different PSUs, or different batteries).
If {{{name}}} and a Passive PoE device are connected with common ground, do not use LAN1 port, other ports can be used (refer to image below):
[[Category:{{{name}}} Manual]]