RUT950 UPNP
Main Page > EOL Products > RUT950 > RUT950 Manual > RUT950 WebUI > RUT950 Services section > RUT950 UPNP
Summary
UPnP allows clients in the local network to automatically configure the router. This chapter is a summary of the UPnP function in RUT routers
General Settings
| FIELD NAME | VALUE | DESCRIPTION |
|---|---|---|
| Enable | yes | no; Default: no | Toggles UPnP ON or OFF |
| Use secure mode | yes | no; Default: yes | Toggles Secure mode ON or OFF |
Advanced Settings
| FIELD NAME | VALUE | DESCRIPTION |
|---|---|---|
| Use UPnP port mapping | yes | no; Default: yes | Toggles UPnP port napping ON or OFF |
| Use NAT-PMP port mapping | yes | no; Default: yes | Toggles NAT-PMP port mapping ON or OFF |
| Device UUID | yes | no; Default: yes | Specify Universal unique ID of the device |
UPnP ACLs
ACLs specify which external ports may be redirected to which internal addresses and ports
| FIELD NAME | VALUE | DESCRIPTION |
|---|---|---|
| Comment | string; Default: Allow high ports | Adds a comment to this rule |
| Ecternal ports | integer [0..65535]] | range of integers [0-65535]; Default: 1024-65535 | External port(s) which may be redirected. May be specified as a single port or a range of ports. To specify a range use a dash ('-') symbol between two integer numbers |
| Internal Addresses | ip/integer [0..32]; Default: 0.0.0.0/0 | Internal address to be redirect to |
| Internal ports | integer [0..65535]] | range of integers [0-655355]; Default: 1024-65535 | Internal port(s) to be redirect to May be specified as a single port or a range of ports. To specify a range use a dash ('-') symbol between two integer numbers |
| Action | allow | deny; Default: allow | Allows or forbids the UPnP service to open the specified port |