BAT120 LEDs
Revision as of 14:15, 13 April 2022 by Gytispieze (talk | contribs) (Gytispieze moved page Draft:BAT120 LEDs to BAT120 LEDs without leaving a redirect)
Main Page > BAT Uninterruptable Power Supplies > BAT120 > BAT120 Manual > BAT120 LEDs
This wiki page contains information about BAT120 LEDs and their actions.
Power IN LED
The IN PWR LED is the left-most located LED on the front panel:
| Action | Description |
|---|---|
| LED turned ON | PSU connected to IN PWR socket |
Power OUT LED
The OUT PWR LED is the second from the left LED located on the front panel:
| Action | Description |
|---|---|
| LED turned ON | OUT PWR socket connected to the device |
Power LEDs
The Power LEDs are located in the middle of the front panel:
| Action | Description |
|---|---|
| LED turned ON | Shows BAT120 state of charge. Each LED equals to 25% of SOC. |
Combined LED states
Some of the states are shown with multiple LEDs:
| Action | Description |
|---|---|
| All LEDs blinking every 500ms | BAT120 overheated. |
| OUT PWR LED blinking every 500ms | OUT PWR shorted. |
| Power LEDs lighting up in sequence | BAT120 is charging. |
| Power LEDs blink every 5 seconds | BAT120 is in sleep mode. |