Line 8: |
Line 8: |
| ---- | | ---- |
| ===[https://wiki.teltonika-networks.com/images/3/32/Quectel_EC25%26EC21_AT_Commands_Manual_V1.3.pdf#page=206&zoom=100,68,804 AT+CCLK Clock] === | | ===[https://wiki.teltonika-networks.com/images/3/32/Quectel_EC25%26EC21_AT_Commands_Manual_V1.3.pdf#page=206&zoom=100,68,804 AT+CCLK Clock] === |
| + | ---- |
| + | The command sets and queries the real time clock (RTC) of the module. The current setting is retained until the module is totally disconnected from power. |
| | | |
− | The command sets and queries the real time clock (RTC) of the module. The current setting is retained until the module is totally disconnected from power.
| + | ===[https://wiki.teltonika-networks.com/images/3/32/Quectel_EC25%26EC21_AT_Commands_Manual_V1.3.pdf#page=207&zoom=100,68,688 AT+CBC Battery Charge] === |
| ---- | | ---- |
− | ===[https://wiki.teltonika-networks.com/images/3/32/Quectel_EC25%26EC21_AT_Commands_Manual_V1.3.pdf#page=207&zoom=100,68,688 AT+CBC Battery Charge] ===
| + | The command returns battery charge status '''<bcs>''' and battery charge level '''<bcl>''' of the MT |
| | | |
− | The command returns battery charge status '''<bcs>''' and battery charge level '''<bcl>''' of the MT
| + | ===[https://wiki.teltonika-networks.com/images/3/32/Quectel_EC25%26EC21_AT_Commands_Manual_V1.3.pdf#page=208&zoom=100,68,498 AT+QADC Read ADC Value] === |
| ---- | | ---- |
− | ===AT+QADC Read ADC Value ===
| + | The command is used to read the voltage value of ADC channel. |
| | | |
− | The command is used to read the voltage value of ADC channel.
| + | ===[https://wiki.teltonika-networks.com/images/3/32/Quectel_EC25%26EC21_AT_Commands_Manual_V1.3.pdf#page=209&zoom=100,68,181 AT+QSCLK Enable/Disable Entering into Sleep Mode] === |
| ---- | | ---- |
− | ===AT+QSCLK Enable/Disable Entering into Sleep Mode ===
| + | The command is used to control whether the module enters into sleep mode. When entering into sleep mode is enabled, DTR is pulled up and WAKEUP_IN is pulled up, the module can directly enter into sleep mode. If entering into sleep mode is enabled, DTR is pulled down and WAKEUP_IN is pulled down, there is a need to pull the DTR pin and the WAKEUP_IN pin up first, and then the module can enter into sleep mode. |
| | | |
− | The command is used to control whether the module enters into sleep mode. When entering into sleep mode is enabled, DTR is pulled up and WAKEUP_IN is pulled up, the module can directly enter into sleep mode. If entering into sleep mode is enabled, DTR is pulled down and WAKEUP_IN is pulled down, there is a need to pull the DTR pin and the WAKEUP_IN pin up first, and then the module can enter into sleep mode.
| |
| | | |
| [[Category:TRM240 AT Commands]] | | [[Category:TRM240 AT Commands]] |