505
edits
Changes
Ignition detection solution (view source)
Revision as of 11:22, 28 August 2023
, 11:22, 28 August 2023→Action configuration
* Control: Output (4) (Output pin on which the relay control is connected).
* Control: Output (4) (Output pin on which the relay control is connected).
* Maintain: Off
* Maintain: Off
* State: Low.
* State copying: On
* Source: Input (3)
Leave everything else as default, press '''Save & Apply'''.
Leave everything else as default, press '''Save & Apply'''.
----
----
'''Disclaimer''': The information contained on this article is meant to provide an example on how to achieve Ignition detection functionality. If you decide to modify, use different components or connect the schematics differently - you are doing so at your own risk.
'''Disclaimer''': The information contained on this article is meant to provide an example on how to achieve Ignition detection functionality. If you decide to modify, use different components or connect the schematics differently - you are doing so at your own risk.
[[Category:Use cases]]
[[Category:Hardware application]]