505
edits
Changes
Ignition detection solution (view source)
Revision as of 14:14, 16 November 2022
, 14:14, 16 November 2022no edit summary
schematic.png
schematic.png
To build this schematic, you would need to use the electrical components as mentioned above, only in this case we will use 2 Relays and 2 Diodes. As mentioned earlier, using this schematic without the diode, raises risk damaging the device.
To build this schematic, you would need to use the same electrical components as mentioned above, only in this case we will use 2 Relays and 2 Diodes. As mentioned earlier, using this schematic without the diode, raises risk damaging the device.
==Device configuration==
==Device configuration==
If you chose the first option, no additional device configuration is needed. If you would like a set up based on the second schematic, you would need to do additional configuring in the device. First of all, we need a custom startup script to toggle a second relay to ON position. Follow these steps to configure startup behavior:
If you chose the first option, no additional device configuration is needed. If you would like a set up based on the second schematic, you would need to do additional configuring in the device.
===Startup script===
----
First of all, we need a custom startup script to toggle a second relay to ON position. Follow these steps to configure startup behavior:
* Navigate to '''System -> Custom scripts -> Startup script'''.
* Navigate to '''System -> Custom scripts -> Startup script'''.
[[File:Startupscriptoutput.png|border|class=tlt-border]]
[[File:Startupscriptoutput.png|border|class=tlt-border]]
===Input/Output Juggler configuration===
----
Input/Output configuration also needs some changes for this functionality to work as intended.
* Navigate to '''Services -> Input/Output -> IO Juggler'''.
* In the general tab, press enable to turn on I/O Juggler functionality.
[[File:Enableiojuggler.png|border|class=tlt-border]]
===Action configuration===
----
* Navigate to Actions tab.
* In the '''Add new instance''' section, input name (delayoff in this example) for action and in '''Type''' select '''Output''', press '''Add'''.
[[File:Addnewinstance.png|border|class=tlt-border]]
In the new window, configure the settings according to the explanations below.
* Type: Output.
* Execution delay (how long you would like to keep the router on after the ignition turns off): your preferred time in seconds.
* Control: Output (4) (Output pin on which the relay control is connected).
* State: Low.
Leave everything else as default, press '''Save & Apply'''.
[[File:Actionsettingsrelay.png|border|class=tlt-border]]
===Instance configuration===
----
Switch back to the '''General''' tab. In the '''Add new instance''' section, select '''Role: Input(3)''' and press '''Add''' to add new instance.
[[File:Generaltabinstancerly.png|border|class=tlt-border]]
In the new window, configure the settings according to the explanations below.
* Press '''Enable''' to enable the instance.
* Trigger interval – 1.
* Trigger – Falling (reacts when state goes from On to Off).
* Add actions – select the action which you‘ve created previously (delayoff in this example).
* Press '''Save & Apply'''.
[[File:Jugglerinstance.png|border|class=tlt-border]]