Difference between revisions of "LAN Traffic Splitting Using Advanced Static Routing Rules"
From Teltonika Networks Wiki
| Line 9: | Line 9: | ||
| − | + | ==Prerequisites== | |
| + | |||
| + | For this particular configuration you will need: | ||
| + | |||
| + | * A Router with 2xLTE modules (RUTX12 is being used in the example) | ||
| + | * 2 SIM cards | ||
| + | * 2 PCs in the same LAN network | ||
| + | |||
| + | ==Preparation== | ||
| + | |||
| + | * Prepare RUTX12, power up the device, insert two sim cards, check that both are active and working. SIM1, SIM2, PWR and signal strength indicators should light up. | ||
| + | * Access the router through WEBUI, go to Network -> Interfaces, make sure that both MOB1S1A1 and MOB2S1A1 interfaces are running (Status = Running). You should also be able to see their Ip addresses. | ||
| + | * Make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings. | ||
| + | |||
| + | |||
| + | '''Network -> Interfaces''' should look similar to this: | ||
| + | |||
| + | [[File:Interfaces.png|center]] | ||
Revision as of 14:21, 11 November 2021
Introduction
This article provides a guide on how to separate mobile data traffic within a LAN by using advanced static routing rules. These configurations are specifically made for RUTX12.
- First you want to make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.
Prerequisites
For this particular configuration you will need:
- A Router with 2xLTE modules (RUTX12 is being used in the example)
- 2 SIM cards
- 2 PCs in the same LAN network
Preparation
- Prepare RUTX12, power up the device, insert two sim cards, check that both are active and working. SIM1, SIM2, PWR and signal strength indicators should light up.
- Access the router through WEBUI, go to Network -> Interfaces, make sure that both MOB1S1A1 and MOB2S1A1 interfaces are running (Status = Running). You should also be able to see their Ip addresses.
- Make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.
Network -> Interfaces should look similar to this:
