Fixed section ["Allowed IPs" - for this config put in 10.0.0.1/32 to 10.0.1.1/32]
Line 1:
Line 1:
+
''Note: this article and all of its configuration examples given here have been configured using the legacy web UI RUT240 firmware '''RUT2XX_R_00.01.14.4'''. For more information about firmware versions, please refer to [[RUT240 Firmware Downloads|RUT240 firmware wiki page]].''
Before getting started with the configuration of port forwarding, the router must be configured using the setup wizard. This wizard is used to configure basic settings on the router.
+
Before getting started with the configuration of port forwarding, the router must be configured using the setup wizard. This wizard is used to configure basic settings on the router.
+
+
Additionally, it's highly recommended to understand the difference and recognize the distinction between public and private IP addresses. A short article regarding this can be found on our wiki FAQ: [[Private and Public IP Addresses]].
=== Initial router configuration ===
=== Initial router configuration ===
Line 345:
Line 349:
"'''Public key'''" - copy and paste the public key of your peer (which was generated by the virtual private server)
"'''Public key'''" - copy and paste the public key of your peer (which was generated by the virtual private server)
−
"'''Allowed IPs'''" - for this config put in 10.0.0.1/32
+
"'''Allowed IPs'''" - for this config put in 10.0.1.1/32