Difference between revisions of "RUT300 LEDs"

From Teltonika Networks Wiki
 
(3 intermediate revisions by one other user not shown)
Line 2: Line 2:
 
<!------------------------DEVICE----------------------->
 
<!------------------------DEVICE----------------------->
 
| name        = RUT300
 
| name        = RUT300
| series      = RUT3
+
| series      = RUT30X
 
<!----------------------SEPARATORS--------------------->
 
<!----------------------SEPARATORS--------------------->
 
| 2g          = 0  <!-- 1 has 2G; 0 doesn't have 2G -->
 
| 2g          = 0  <!-- 1 has 2G; 0 doesn't have 2G -->
 
| eth        = 1  <!-- 1 has ETH; 0 doesn't have ETH -->
 
| eth        = 1  <!-- 1 has ETH; 0 doesn't have ETH -->
| eth_leds    = 2 <!-- 1 for green; 2 for green & orange-->
+
| eth_leds    = 3 <!-- 1 for green; 2 for green & orange; 3 for orange-only-->
 
| mobile      = 0  <!-- 1 has mobile; 0 doesn't have mobile -->
 
| mobile      = 0  <!-- 1 has mobile; 0 doesn't have mobile -->
 
| mobile_leds = 0  <!-- number of mobile signal strength type LEDs -->
 
| mobile_leds = 0  <!-- number of mobile signal strength type LEDs -->
Line 12: Line 12:
 
| wan        = 0  <!-- 1 has WAN type LEDs; 0 doesn't have WAN type LEDs -->
 
| wan        = 0  <!-- 1 has WAN type LEDs; 0 doesn't have WAN type LEDs -->
 
| wifi        = 0  <!-- 1 has WiFi band LEDs; 0 doesn't have WiFi band LEDs -->
 
| wifi        = 0  <!-- 1 has WiFi band LEDs; 0 doesn't have WiFi band LEDs -->
 +
| gigabit    = 0  <!-- 0 if doesn't have gigabit eth ports -->
 
}}
 
}}

Latest revision as of 14:22, 6 April 2022

Main Page > RUT Routers > RUT300 > RUT300 Manual > RUT300 LEDs

This page contains information the different types of LEDs and their behaviour on a RUT300 device.

Power LED

The power LED is located on the bottom left corner of the front panel, just under the power connector.

Networking rut300 manual leds power led.png

It indicates whether the device is powered on or not.

State Description
LED turned on Device is powered on.
LED turned off Device is not powered on.

Ethernet port LEDs

There is one LEDs located at the top-left of each Ethernet port (top-right green port is unused).

Networking rut300 manual leds ethernet leds.png

They provide information on the current states of the Ethernet ports. Each port has one LED:

  • Orange - 10/100 Mbps connection

Below is an explanation on the behaviours of orange LEDs.

State Description
LED on A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred).
LED off No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card)).
LED blinking Connection established and data is being transferred over this port.