RUT300 Network

Main Page > RUT Routers > RUT300 > RUT300 Manual > RUT300 WebUI > RUT300 Status section > RUT300 Network

The information in this page is updated in accordance with firmware version RUT30X_R_00.07.06.8.


Summary

The Network page contains information related to the device's networking. This chapter is an overview of the Network page in RUT300 devices.

If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. You can do that by clicking the "Advanced" button, located at the top of the WebUI.

Networking rutos manual webui basic advanced mode 75.gif


LAN

This tab displays information about the device's local network(s). The figure below is an example of the Network window:

Networking rutos manual network lan v4.png

lan information
Name LAN interface name
IP address IP address of the LAN interface
Netmask Netmask of the LAN interface. In a sense, a netmask specifies the size of a network. In other words, it indicates which part of the IP address denotes the network, and which denotes the device
dhcp leases
Hostname Hostname of a LAN client
IP Address IP address of a LAN client
MAC Address MAC address of a LAN client
Leasetime Remaining Remaining lease time for a DHCP client. Active DHCP lease holders will try to renew their DHCP leases after a half of the lease time passes.
Static Lease This action will reserve currently assigned IP address for the device in Network -> Interfaces -> Static leases.

Firewall

This tab displays information about the device's firewall. Info is shown of IPv4 and IPv6 traffic. The figure below is an example of the Firewall page tables:

Networking rutos manual status network firewall nat v1.png

Networking rutos manual status network firewall raw v1.png

Networking rutos manual status network firewall mangle v1.png

Networking rutos manual status network firewall filter v1.png

Field name Description
Reset counters Resets all traffic and packet fields
Name Name of the chain
Traffic Size of traffic that was matched to the chain
Packets Count of packets that were matched to the chain
Policy Policy for traffic entering the zone.
Rules Count of rules the chain has
References Count of times the chain was referenced in other chains


For more information about specific firewall chain, INFO button can be pressed. Window like this should pop up:

Networking rutos manual status network firewall info.png

Field name Description
Traffic Size of traffic that was matched to the rule
Packets Count of packets that were matched to the rule
Target Name of the rule (if highlighted you can click it to open modal to it)
Protocol Filters by Internet protocol
In Filters by inbound interface
Out Filters by outbound interface
Source Filters by source address
Destination Filters by destination address
Options Additional iptables options
Comment Filters by comment



Topology

The Topology tab allows scanning of WAN, LAN or both interfaces via arp scan to check active connected devices. After scan it shows how many active devices were found and on which interface.

Networking rutos manual status network topology graf v1.png

All active devices

This section displays the results of the scan.

Networking rutos manual status network topology table v1.png

field name description
Hostname (Vendor) Hostname of scanned device
IP Address IP address of scanned device
MAC Address MAC address of scanned device
Type The type of connection
Interface The interface the scanned device is connected