Changes

SNMP configuration example (view source)

Revision as of 08:22, 17 September 2019

108 bytes added , 08:22, 17 September 2019

Line 155: Line 155:

==Trap Configuration==

−

First enable SNMP Trap, then enter '''Host/IP''', Hots/IP is the SNMP manager, computer to which SNMP agent will send Trap messages. If router is connected to PC via ethernet cable, enter the IP address of the interface the router is connected to. You can use '''ipconfig''' command on windows, '''ifconfig''' on linux to find IP address of the interface to which router is connected. Next choose '''port''', preferably choose port number higher than '''1024''' so SNMP manager could establish connection without root/admin rights.

+

First enable SNMP Trap, then enter '''Host/IP''', Hots/IP is the SNMP manager, computer to which SNMP agent will send Trap messages. If router is connected to PC via ethernet cable, enter the IP address of the interface the router is connected to. You can use '''ipconfig''' command on windows, '''ifconfig''' on linux to find IP address of the interface to which router is connected. Next choose '''port''', preferably choose port number higher than '''1024''' so SNMP manager could establish connection without root/admin rights. If you choose to leave default port '''162''' make sure to launch SNMP manager with admin/root permissions.

[[File:Networking device configurationexample trap configurations v1.png]]

Akademija

0

edits