Setting up WAN as LAN
From Teltonika Networks Wiki
Revision as of 11:47, 2 June 2020 by ErnestasB (talk | contribs) (Created page with "==Introduction== This article provides a guide on how to configure WAN port as LAN. These configurations are specifically made for RutOS devices (RUTX, RUT3, TRB1, TRB2). ===...")
Main Page > General Information > Configuration Examples > LAN > Setting up WAN as LAN
Introduction
This article provides a guide on how to configure WAN port as LAN. These configurations are specifically made for RutOS devices (RUTX, RUT3, TRB1, TRB2).
Configuring WAN as LAN
- First you want to make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.
- After that navigate to Network > Interfaces and disable WAN interface so it won't interfere with the configuration of its port.
File:Disable WAN interface.png
- Next we will edit our LAN interface and navigate to Physical settings where we will add Interface item from the dropdown menu.
File:LAN Physical settings interface.png
- Select Ethernet Adapter item, which should hold (wan and wan6).
File:Interface item dropdown.png
- It should result in something like this.
File:Changed lan interface physical settings.png
- Once you're done with configurations above just save any changes you made. Now head to VLAN settings and check if WAN VLAN ID 1 and 2 set right.
File:VLAN for wan to lan config.png
From this point, WAN port should work as LAN. Go ahead and try to swap from your to current port to WAN, you should be able to ping the router.
