TRB143 First Start
This Wiki page contains the online version of the Quick Start Guide (QSG) for the TRB143 LTE Ethernet Gateway. Here you will find an overview of the various components found on the front and back sides of a TRB143 device, basic hardware installation, first login information, device specifications and general safety information. It is highly recommended that you acquaint yourself with with the Quick Start Guide before using the device. If you own a TRB143 device, you can also find a printed version of the Quick Start Guide in the device's package.
Front view
| No. | Description |  |
|---|---|---|
| 1 | Power LED | |
| 2 | Power socket | |
| 3 | M-Bus port | |
| 4 | Ethernet port | |
Back view
| No. | Description |  |
|---|---|---|
| 1 | SIM card slot | |
| 2 | Mobile antenna connector | |
| 3 | Mobile connection type LEDs | |
| 4 | Mobile signal strength indication LEDs | |
| 5 | USB connector | |
| 6 | Reset button | |
Connectors
Device configuration
1. Power on the device and connect the USB cable to your computer.
2. Allow the gateway to boot up. This might take up to 30 s.
3. Your computer's OS should detect the USB device and install the drivers for the virtual NDIS network adapter. IP address is set automatically via DHCP.
4. Use a Web browser to go to gateway's default address: http://192.168.2.1
5. Use the following credentials to login:
6. Go to the WebUI's Status → Overview page to check the signal strength:
Safety information
TRB143 gateway must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments.
| Radio specifications | |
|---|---|
| RF technologies | 2G, 3G, 4G |
| Max. RF power | 33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE |
| Bundled accessories specifications* | |
| Power adapter | Input: 0.6 A@100-240 VAC, Output: 12VDC, 1.5 A, 4-pin plug |
| Mobile antenna | 699-868/1850-2690 MHz, 50 Ω, VSWR<3, gain** 1 dBi, omnidirectional, SMA male connector |
* Order code dependent.
** Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.
This sign on the package means that is necessary to read the User's Manual before you start using the device
This sign on the package means that all used electronic and electric equipment should not be mixed with general household waste
