TSW110 LEDs

From Teltonika Networks Wiki
Revision as of 08:37, 22 January 2021 by LorurnA (talk | contribs) (LorurnA moved page Draft:TSW110 LEDs to TSW110 LEDs without leaving a redirect)

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Main Page > TSW Switches > TSW110 > TSW110 Manual > TSW110 LEDs

This page contains information the different types of LEDs and their behaviour on a TSW110 device.

Power LED

The power LED is located on the bottom left corner of the front panel, just under the power connector.

Networking tsw110 manual leds power led.png

It indicates whether the device is powered on or not.

State Description
LED turned on Device is powered on.
LED turned off Device is not powered on.

Ethernet port LEDs

There are two LEDs located at the top of each Ethernet port.

Networking tsw110 manual leds ethernet leds.png

They provide information on the current states of the Ethernet ports. Each port has two LEDs:

  • Orange - 10/100 Mbps connection
  • Green- 1000 Mbps connection

Below is an explanation on the behaviours of green and orange LEDs.

State Description
LED on A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred).
LED off No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card).
LED blinking Connection established and data is being transferred over this port.