Template:Networking bat1xx first start hardware installation
From Teltonika Networks Wiki
Revision as of 14:07, 5 April 2022 by Gytispieze (talk | contribs) (Created page with "==Hardware installation== <ol> <li>Connect Teltonika Network device power input (<b>PWR</b>) with BAT120 power output (<b>OUT PWR</b>) using provided 4-pin to 4-pin cable...")
Hardware installation
- Connect Teltonika Network device power input (PWR) with BAT120 power output (OUT PWR) using provided 4-pin to 4-pin cable.
- Connect PSU 4-pin plug to BAT120 power input (IN PWR) to power up BAT120 and the end device.
BAT120 Charging
- Set On/Off slider located on BAT120 front panel to On.
- Connected provided PSU to IN PWR socket.
- As BAT120 starts charging, it will also power the Teltonika Network device connected to the OUT PWR socket.