Difference between revisions of "Template:Networking device leds"

From Teltonika Networks Wiki
(Added information on Signal Strength LEDs and reset button when no User's defaults are configured.)
 
Line 79: Line 79:
  
  
The signal strength LEDs can also be used as a <b>time indicator for holding the reset button</b>. When you press and hold the reset button, if there is a User's default configuration configured on the device, you have to hold it pressed for 6 seconds (by default) to initiate a <b>User's default configuration reset</b> and 12 seconds (by default) to initiate a <b>Factory reset</b>. Otherwise, it is only necessary to hold the reset button for 6 seconds to trigger a <b>Factory reset</b>. If the button was held down longer than 20 seconds (by default) no action will be taken.  
+
The signal strength LEDs can also be used as a <b>time indicator for holding the reset button</b>. By default,  when you press and hold the reset button, after 6 seconds it initiates a <b>Factory reset</b>. If there is a User's default configuration configured on the device, you have to hold it pressed for 6 seconds (by default) to initiate a <b>User's default configuration reset</b> and 12 seconds (by default) to initiate a <b>Factory reset</b>. If the button was held down longer than 20 seconds (by default) no action will be taken.  
  
 
While holding the reset button each lit up signal strength LED indicate that a period of two seconds has passed. In case with <b>{{{name}}}</b>, when all {{{sig_led_num}}} signal strength LEDs are lit up, they represent that {{#expr: {{{sig_led_num}}} * 2}} (LED number multiplied by 2) seconds have passed since you pressed down on the reset button.
 
While holding the reset button each lit up signal strength LED indicate that a period of two seconds has passed. In case with <b>{{{name}}}</b>, when all {{{sig_led_num}}} signal strength LEDs are lit up, they represent that {{#expr: {{{sig_led_num}}} * 2}} (LED number multiplied by 2) seconds have passed since you pressed down on the reset button.

Latest revision as of 12:11, 15 March 2023

This wiki page contains information about {{{name}}} router LEDs and their actions.

Power LED

The power LED is located on the bottom left corner of the front panel, near the power connector:

[[File:{{{file_power_led}}}|{{{size_power_led}}}px]]

It can perform two different actions:

Action Description
LED turned ON Router is powered up
LED turned OFF Router is not power up





[[Category:{{{name}}} Manual]]