Changes

==Summary==

==Summary==

A <b>factory reset</b> returns the device back to its default factory settings, i.e., it deletes all custom configurations. This chapter is an overview on the various ways of performing a <b>factory reset</b> on a {{{name}}} device.

This chapter is an overview on the various ways of performing a <b>factory reset</b> on a {{{name}}} device.

<b>NOTE</b>: SIM PIN on the main SIM card is the only user parameter that is kept after a factory reset.

<b>NOTE</b>: SIM PIN on the main SIM card is the only user parameter that is kept after a factory reset.

==Reset Button==

==Default login information==

 

 

 

 

The <b>reset button</b> is located on the {{#ifeq:{{{name}}}|RUT850|front|back}} {{#ifeq:{{{series}}}|TRB14x|side|panel}} of the device:

The <b>reset button</b> is located on the {{#ifeq:{{{name}}}|RUT850|front|back}} {{#ifeq:{{{series}}}|TRB14x|side|panel}} of the device:

</ul>

</ul>

==WebUI==

===WebUI===

 

You can also perform a factory reset from the router's WebUI. To do so, login to the router and go to the Administration section found under the System tab (<b>System → Administration → [[{{{name}}}_Administration#General|General]]</b>). In the very bottom of the page there's a <b>Restore</b> button that performs a factory reset on click:

You can also perform a factory reset from the router's WebUI. To do so, login to the router and go to the Administration section found under the System tab (<b>System → Administration → [[{{{name}}}_Administration#General|General]]</b>). In the very bottom of the page there's a <b>Restore</b> button that performs a factory reset on click:

<!--==SMS-->

<!--==SMS-->

{{#ifeq:{{{series}}}|TRB14x||{{Template: Networking_device_manual_device_recovery_sms|name = {{{name}}}}}}}

{{#ifeq:{{{series}}}|TRB14x||{{Template: Networking_device_manual_device_recovery_sms|name = {{{name}}}}}}}

==Command line==

===Command line===

 

You can perform a factory reset via command line by executing the <b>{{#ifeq:{{{series}}}|TRB14x|factory_restore|firstboot}}</b> command. After this you will be asked to confirm the reset. If you're sure, type the letter <b>y</b> and press "Enter" or type the letter <b>n</b> if you wish to cancel the reset.

You can perform a factory reset via command line by executing the <b>{{#ifeq:{{{series}}}|TRB14x|factory_restore|firstboot}}</b> command. After this you will be asked to confirm the reset. If you're sure, type the letter <b>y</b> and press "Enter" or type the letter <b>n</b> if you wish to cancel the reset.

}}

}}

==Default login information==

      | {{Template: Networking_device_manual_device_recovery_bootloader|name={{{name}}}|series={{{series}}}}}

 

==RMA==

Since all configurations are deleted and restored to defaults after a factory reset, you'll need to use the default authentication info in order to login to the device. The default login information is provided below:

If conventional recovery methods do not help, you may need to send the device to warranty for repair. The warranty process is described <b>[https://teltonika-networks.com/warranty-repair/ here]</b>.

[[Category:{{{name}}} Manual]]

[[Category:{{{name}}} Manual]]