9,561
edits
Changes
Template:Networking rut2xx manual vpn ipsec (view source)
Revision as of 08:48, 19 August 2021
, 08:48, 19 August 2021no edit summary
The <b>IPsec configuration</b> section is used to configure the main parameters of an IPsec connection. Refer to the figure and table below for information on the configuration fields located in the general settings section.
The <b>IPsec configuration</b> section is used to configure the main parameters of an IPsec connection. Refer to the figure and table below for information on the configuration fields located in the general settings section.
[[File:{{{file_ipsec_config}}}]]
[[File:{{{file_ipsec_config}}}|border|class=tlt-border]]
<table class="nd-mantable">
<table class="nd-mantable">
<td>ip/netmask; default: <b>none</b></td>
<td>ip/netmask; default: <b>none</b></td>
<td>Remote network IP address and subnet mask used to determine which part of the network can be accessed in the VPN network. Netmask range [0..32]. This value must differ from the device’s LAN IP</td>
<td>Remote network IP address and subnet mask used to determine which part of the network can be accessed in the VPN network. Netmask range [0..32]. This value must differ from the device’s LAN IP</td>
</tr>
<tr>
<td>Passthrough networks</td><td>None | LAN | Wired | WiFi | Mobile | custom; default: '''none'''</td>
<td>Select networks which should be passthrough and excluded from routing through tunnel</td>
</tr>
</tr>
<tr>
<tr>
<td>yes | no; default: <b>no</b></td>
<td>yes | no; default: <b>no</b></td>
<td>Allows WebUI access for hosts in the VPN network</td>
<td>Allows WebUI access for hosts in the VPN network</td>
</tr>
<tr>
<td>Compatibility mode</td>
<td>yes | no; default: <b>no</b></td>
<td>Enable this if multiple subnets do not work with a 3rd party IPsec peer.</td>
</tr>
</tr>
<tr>
<tr>
