Changes

As seen in the example above, you can change the value of an output by using the <i>invert</i> command, which simply turns the current value of the specified output into its opposite state.

As seen in the example above, you can change the value of an output by using the <i>invert</i> command, which simply turns the current value of the specified output into its opposite state.

----

----

To get the value of the analog input use the <i>analog_calc</i> command. For example:

To get the value of the analog input use the <i>cat /sys/class/hwmon/hwmon0/device/in0_input</i> command. Router will show voltage value in '''mV'''. For example:

<pre>

<pre>

root@Teltonika:~# analog_calc

root@Teltonika:~# cat /sys/class/hwmon/hwmon0/device/in0_input

</pre>

</pre>