9,561
edits
Changes
Template:Networking rut manual modbus (view source)
Revision as of 12:09, 24 October 2023
, 12:09, 24 October 2023Text replacement - "\{\{Template: Networking_rutos_manual_fw_disclosure (.*) (.*) (.*) (.*) \}\}" to "{{Template: Networking_device_manual_fw_disclosure | series = {{{series}}} | name = {{{name}}} | fw_version ={{Template: Networking_device_manual_latest_fw | series = {{{series}}} | name = {{{name}}} }} }}"
{{Template: Networking_rutos_manual_fw_disclosure
{{Template: Networking_device_manual_fw_disclosure
| fw_version = {{#switch: {{{series}}}
| series = {{{series}}}
| name = {{{name}}}
| fw_version ={{Template: Networking_device_manual_latest_fw
| series = {{{series}}}
| series = {{{series}}}
| name = {{{name}}}
}}
}}
}}
==Summary==
==Summary==
</tr>
</tr>
<tr>
<tr>
<td><span style="color: red;">Trigger output:</span> Output</td>
<td><span style="color: red;">Trigger output:</span> Output</td>{{#ifeq:{{{name}}}|RUT955|
<td>Open collector output | Relay output | Both; default: <b>Open collector output</b></td>
<td>Open collector output {{!}} Relay output {{!}} Both; default: <b>Open collector output</b></td>|
<td>4PIN output; default: <b>4PIN output</b></td>}}
<td>Which output(s) will be triggered.</td>
<td>Which output(s) will be triggered.</td>
</tr>
</tr>
This section is used to configure the Modbus RTU master's RS232 serial interface settings. Refer to the figure and table below for information on RS232 configuration.
This section is used to configure the Modbus RTU master's RS232 serial interface settings. Refer to the figure and table below for information on RS232 configuration.
[[File:Networking_rut_manual_modbus_modbus_serial_master_rs232.png|borer|class=tlt-border]]
[[File:Networking_rut_manual_modbus_modbus_serial_master_rs232.png|border|class=tlt-border]]
<table class="nd-mantable">
<table class="nd-mantable">
</tr>
</tr>
<tr>
<tr>
<td>Period</td>
<td>Frequency settings period</td>
<td>integer [1..9999]; default: <b>10</b></td>
<td>Period {{!}} Schedule; default: <b>Period</b></td>
<td>Interval (in minutes) at which requests are sent to the slave device.</td>
<td>Specifies whether request frequency should happen every x amount of seconds (<i>Period</i>) or on a set schedule (<i>Schedule</i>).</td>
</tr>
<tr>
<td>Period/Schedule</td>
<td>integer [1..9999]/; default: <b>10</b></td>
<td>Interval (in minutes) at which requests are sent to the slave device. Or Shedule (crontab-like, three fields (HH MM SS); e.g.. <i>0,12 * *</i>).</td>
</tr>
</tr>
</table>
</table>
