Changes

As you may notice from the image above, the configuration is very simple. You can assign ratio values to WAN interfaces. The ratio values represent a percentage of load that will go through an interface. For example, if you set that 3 parts of traffic would go through the  

As you may notice from the image above, the configuration is very simple. You can assign ratio values to WAN interfaces. The ratio values represent a percentage of load that will go through an interface. For example, if you set that 3 parts of traffic would go through the  

{{#ifeq:{{mobile}}

{{#switch: {{{name}}}

Mobile

  interface and 2 parts would go through the Wired interface, it would mean that roughly 60% (3/5) of data will be transferred through Mobile, 40% (2/5) through Wired. If the ratios would be different, say Mobile: 5, Wired: 10, then 33% (5/15) of data would be transferred through Mobile, and 66% (10/15) would go through Wired.  

| RUTX12 = Mobile

  interface and 2 parts would go through the Wired interface, it would mean that roughly 60% (3/5) of data will be transferred through  

| RUTX11 = Mobile

, 40% (2/5) through Wired. If the ratios would be different, say  

| RUTXR1 = Mobile

: 5, Wired: 10, then 33% (5/15) of data would be transferred through  

| RUTX11 = Mobile

, and 66% (10/15) would go through Wired.  

If you press Edit button, you will be transferred to the same interface settings that were described in [[#Failover|Failover section]].

If you press Edit button, you will be transferred to the same interface settings that were described in [[#Failover|Failover section]].

[[Category:{{{name}}} Network section]]

[[Category:{{{name}}} Network section]]