Teltonika Networks Wiki

Changes

Template:Networking rutos manual input output (view source)

Revision as of 16:26, 4 November 2020

1,603 bytes removed ,  16:26, 4 November 2020
no edit summary
Line 12: Line 12:  
| series = {{{series}}}
 
| series = {{{series}}}
 
}}
 
}}
 +
==Physical characteristics and I/O pin mapping==
   −
{{#switch: {{{series}}}
+
{{Template:Networking_rutos_manual_input_output_pinout
−
| RUTX =
+
| series        = {{{series}}}
−
==Power Socket Pinout==
+
| configurableio = {{{configurableio}}}
−
 
+
| input_volts    = {{{input_volts}}}
−
The router's input/output pins can be found inside the power socket:
+
}}
−
 
+
{{#ifeq: {{{name}}} | TRB141 |
−
[[File:Networking_rutos_manual_input_output_power_socket_pinout_configurableio_{{{configurableio}}}.png]]
+
===Input/Output Connector Pinout===
 
----
 
----
−
The electric characteristics for the input and output pins are as follows:
+
[[File:Networking_trb141_manual_input_output_input_output_connector_pinout.png]]
−
<ul>
  −
    <li><b>Power</b>: 9-50 VDC positive (+).</li>
  −
    <li><b>Ground</b>: negative/ground (-).</li>
  −
    <li><b>Input</b>: digital non-isolated input.
  −
        <ul>
  −
            <li><i>logical low level:</i> 0 - 5 V;</li>
  −
            <li><i>logical high level:</i> 8 - 40 V.</li>
  −
        </ul>
  −
    </li>
  −
    <li><b>Output</b>: digital open collector (OC) output; 30 V, 300 mA.</li>
  −
</ul>
  −
| TRB1 =
  −
{{#ifeq:{{{name}}}|TRB141
  −
|
  −
==Characteristics==
  −
 
  −
TRB141 has eighteen input/output pins, two of them can be found inside the power socket and the rest sixteen are on the side of the device. A list of Input/Output electric characteristics inherent in TRB141 devices can be found below.
  −
 
  −
===Power Socket Pinout===
  −
----
  −
[[File:Networking_rutos_manual_input_output_power_socket_pinout_configurableio_{{{configurableio}}}.png]]
      
<ul>
 
<ul>
−
     <li><b>Power</b>: 9-30 VDC positive (+).</li>
+
     <li><b>DI<sub>1</sub></b> & <b>DI<sub>2</sub></b> - DRY/WET configurable inputs:
−
    <li><b>Ground</b>: negative/ground (-).</li>
  −
    <li><b>I/O</b>: programmable input/output pins; can be set to:
   
         <ul>
 
         <ul>
−
             <li><i>open collector (OC) output;</i> max 30 V;</li>
+
             <li><b>WET</b>: 0-1.9 V is detected as logical "0"; 1.9-3.8 V is detected as logical "1"</li>
−
             <li><i>digital input;</i> 0-7.3 V is detected as logical "0"; 7.3-30 V is detected as logical "1".</li>
+
             <li><b>DRY</b>: is detected as logical "0" when the input is shorted to GND; otherwise is detected as logical "1"</li>
 
         </ul>
 
         </ul>
 
     </li>
 
     </li>
−
</ul>
+
    <li><b>NC<sub>1</sub></b>, <b>C<sub>1</sub></b> & <b>NO<sub>1</sub></b> - Normally Closed, Common and Normally Open contacts of the internal Non-Latching Relay respectively.<br>Maximum relay ratings: 0.5 A at 60 VDC/70 VAC, 1 A at 30 VDC/VAC.</li>
−
 
+
    <li><b>NC<sub>2</sub></b>, <b>C<sub>2</sub></b> & <b>NO<sub>2</sub></b> - Normally Closed, Common and Normally Open contacts of the internal Latching Relay respectively.<b>Maximum relay ratings: 0.8 A at 70 VDC, 0.9 A at 70 VAC, 2 A at 30 VDC/VAC.</li>
−
===Input/Output Connector Pinout===
+
    <li><b>A</b> - ADC input. Analog voltage range: 0-30 V. The input can be configured for 4-20 mA sensor protocol as current measurement of 0-30 mA.</li>
−
----
+
     <li><b>l</b> and <b>⏚</b> - isolated input contacts.
−
[[File:Networking_trb141_manual_input_output_input_output_connector_pinout.png]]
  −
 
  −
*'''DI1''' and '''DI2''' are DRY/WET configurable inputs. WET: 0-1.9 V is detected as logical "0", 1.9-3.8 V is detected as logical "1".  DRY: Logical "0" is detected when input is shorted to GND, otherwise  input is detected as logical "1".
  −
*'''NC<sub>1</sub> C<sub>1</sub>''' and '''NO<sub>1</sub>''' are respectively Normally Closed, Common and Normally Open contacts of internal Non-Latching Relay. Maximum relay ratings: 0.5A at 60 VDC/70 VAC, 1A at 30 VDC/VAC.
  −
*'''NC<sub>2</sub> C<sub>2</sub>''' and '''NO<sub>2</sub>''' are respectively Normally Closed, Common and Normally Open contacts of internal Latching Relay. Maximum relay ratings: 0.8A at 70 VDC, 0.9A at 70 VAC, 2A at 30 VDC/VAC.
  −
*'''A''' is ADC input. Analog voltage range 0 - 30 V. Input can be configured for 4-20mA sensor protocol as current measurement of 0 - 30 mA.
  −
*'''l''' and '''⏚''' are isolated input contacts. 0-7.3 V is detected as logical "0",  7.3-71 V is detected as logical "1".
  −
*'''+''' is power output connected directly to gateway's power supply input pin.  This Output can be used for powering external 4-20 mA current sensor.
  −
*'''3.8''' is 3.8V power output which can be used to power 1-Wire sensors when needed.
  −
*'''1W''' 1-Wire protocol input/output.
  −
*'''⏚''' is GND contact.
  −
 
  −
|
  −
 
  −
==Characteristics==
  −
 
  −
{{{name}}} input/output pins can be found inside the power socket:
  −
 
  −
===Power Socket Pins===
  −
----
  −
[[File:Networking_rutos_manual_input_output_power_socket_pinout_configurableio_{{{configurableio}}}.png]]
  −
 
  −
<ul>
  −
    <li><b>Power</b>: 9-30 VDC positive (+).</li>
  −
     <li><b>Ground</b>: negative/ground (-).</li>
  −
    <li><b>I/O</b>: programmable input/output pins; can be set to:
   
         <ul>
 
         <ul>
−
             <li><i>open collector (OC) output;</i> max 30 V;</li>
+
             <li>0-7.3 V is detected as logical "0"</li>
−
             <li><i>digital input;</i> 0-5 V is detected as logical "0"; 8-40 V is detected as logical "1".</li>
+
             <li>7.3-71 V is detected as logical "1"</li>
 
         </ul>
 
         </ul>
 
     </li>
 
     </li>
−
</ul>
+
    <li><b>+</b> - a power output connected directly to gateway's power supply input pin. This Output can be used to power an external 4-20 mA current sensor.</li>
−
}}
+
    <li><b>3.8</b> is a 3.8 V power output that can be used to power 1-Wire sensors.</li>
−
 
+
    <li><b>1W</b> - 1-Wire protocol input/output.</li>
−
| TRB2XX =
+
    <li><b>⏚</b> - GND contact.</li>
−
 
+
</ul>|}}
−
|
  −
}}
      
==Status==
 
==Status==
Retrieved from "https://wiki.teltonika-networks.com/view/Special:MobileDiff/74706"