Difference between revisions of "Template:Networking rutos manual modbus modbus tcp set parameters table"
From Teltonika Networks Wiki
Gytispieze (talk | contribs) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 36: | Line 36: | ||
<td>Relay output status</td> | <td>Relay output status</td> | ||
<td>202</td> | <td>202</td> | ||
| − | <td> | + | <td>203</td> |
<td>1 {{!}} 0</td> | <td>1 {{!}} 0</td> | ||
<td>Toggles DOUT2 ON or OFF</td> | <td>Toggles DOUT2 ON or OFF</td> | ||
| Line 150: | Line 150: | ||
<td>1{{!}}0</td> | <td>1{{!}}0</td> | ||
<td>Toggles PIN 2 ON or OFF</td> | <td>Toggles PIN 2 ON or OFF</td> | ||
| + | </tr> | ||
| + | <tr> | ||
| + | <td> Switch PIN 3 direction </td> | ||
| + | <td>326</td> | ||
| + | <td>327</td> | ||
| + | <td>1{{!}}0</td> | ||
| + | <td>Toggles PIN 3 direction between INPUT (0) or OUTPUT (1)</td> | ||
| + | </tr> | ||
| + | <tr> | ||
| + | <td> Switch PIN 4 direction </td> | ||
| + | <td>327</td> | ||
| + | <td>328</td> | ||
| + | <td>1{{!}}0</td> | ||
| + | <td>Toggles PIN 4 direction between INPUT (0) or OUTPUT (1)</td> | ||
</tr> | </tr> | ||
|}} | |}} | ||
Revision as of 16:10, 27 January 2023
Set Parameters
The Modbus daemon can also set some device parameters.
| value to set | register address | register number | register value | description |
|---|---|---|---|---|
| Hostname | 7 | 8 | Hostname (in decimal form) | Changes hostname |
| Device name | 71 | 72 | Device name (in decimal form) | Changes device name |
| Reboot | 206 | 207 | 1 | Reboots the router |
| Switch PIN 3 state | 324 | 325 | 1|0 | Toggles PIN 3 ON or OFF, when output is selected |
| Switch PIN 4 state | 325 | 326 | 1|0 | Toggles PIN 4 ON or OFF, when output is selected |
| Switch PIN 3 direction | 326 | 327 | 1|0 | Toggles PIN 3 direction between INPUT (0) or OUTPUT (1) |
| Switch PIN 4 direction | 327 | 328 | 1|0 | Toggles PIN 4 direction between INPUT (0) or OUTPUT (1) |
| Change LAN IP | 394 | 395 | IPv4 (in decimal form) | Changes device LAN IP |
