31,703
edits
Changes
Template:Networking rutos manual serial utilities (view source)
Revision as of 13:15, 23 November 2022
, 13:15, 23 November 2022no edit summary
<tr>
<tr>
<td>Full Duplex</td>
<td>Full Duplex</td>
<td>off | on; default: <b>off</b></td>
<td>off {{!}} on; default: <b>off</b></td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
</tr>|}}
</tr>|}}
<td>Stop bits</td>
<td>Stop bits</td>
<td>1 | 2; default: <b>1</b></td>
<td>1 | 2; default: <b>1</b></td>
<td>Stop bits sent at the end of every character allow the receiving signal hardware to detect the end of a character and to resynchronise with the character stream. Electronic devices usually use one stop bit. Two stop bits are required if slow electromechanical devices are used.</td>
<td>Stop bits sent at the end of every character allow the receiving signal hardware to detect the end of a character and to resynchronize with the character stream. Electronic devices usually use one stop bit. Two stop bits are required if slow electromechanical devices are used.</td>
</tr>
</tr>
<tr>
<tr>
<tr>
<tr>
<td>Full Duplex</td>
<td>Full Duplex</td>
<td>off | on; default: <b>off</b></td>
<td>off {{!}} on; default: <b>off</b></td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
</tr>|}}
</tr>|}}
<tr>
<tr>
<td>Full Duplex</td>
<td>Full Duplex</td>
<td>off | on; default: <b>off</b></td>
<td>off {{!}} on; default: <b>off</b></td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
<td>Turns Full Duplex mode on or off. This option is available only on the RS485 device.</td>
</tr>|}}
</tr>|}}