Changes

=====Mesh Node=====

=====Mesh Node=====

Mesh node is configured the same way as mesh gateway. Node has to match gateway's wireless mesh interface configuration. Additionally, LAN interface has to be setup as DHCP client:

Mesh node is configured the same way as mesh gateway. Node has to match gateway's wireless mesh interface configuration. Additionally, WAN interface has to be setup as DHCP client:

1. Access router‘s WebUI. Navigate to Network → Interfaces.

1. Access router‘s WebUI. Navigate to Network → WAN.

2. Press pencil icon on the right of the LAN interface.

2. Press edit button on the right of the WAN interface.

[[File:Networking rutx11 configuration example wireless mesh mesh node configuration 1 v4.png|border|class=tlt-border]]

[[File:Networking rutx11 configuration example wireless mesh mesh node configuration 1 v5.png|border|class=tlt-border]]

3. Change Protocol to DHCP.

3. Change Protocol to DHCP and select necessary device . Click '''Save & Apply''' and If everything was setup correctly, mesh node should be ready use.

 

 

Click '''Save & Apply''' and If everything was setup correctly, mesh node should be ready use.

====Multi AP====

====Multi AP====

The <b>Multi AP</b> feature is used to configure access to multiple wireless access points from one page. To create Multi AP wireless interface click the 'Add' button below of wireless interface in the Network → Wireless page:

The <b>Multi AP</b> feature is used to configure access to multiple wireless access points from one page. To create Multi AP wireless interface click the 'Add' button below of wireless interface in the Network → Wireless page:

[[File:Networking rutos manual wireless mesh gateway add button v4.png|border|class=tlt-border]]

[[File:Networking rutos manual wireless mesh gateway add button v5.png|border|class=tlt-border]]

In General Setup tab change Mode to Multi AP, select desired Network which will be attached to the interface. You can also select scan time and upload file with Access Points list.

In General Setup tab change Mode to Multi AP, select desired Network which will be attached to the interface. You can also select scan time and upload file with Access Points list.

[[File:Networking_rutos_manual_wireless_multi_ap_create_network_v2.png|border|class=tlt-border]]

[[File:Networking_rutos_manual_wireless_multi_ap_create_network_v3.png|border|class=tlt-border]]

=====Access Points=====

=====Access Points=====

You can either configure multiple <b>access points</b> from this page of the WebUI or you can upload a file with a list of access point configurations. The file should contains WiFi access point configuration options and values, which should be defined as <b>option: value</b> (for example, <i>ssid: home_wifi</i>). The SSID option is mandatory.

You can either configure multiple <b>access points</b> from this page of the WebUI or you can upload a file with a list of access point configurations. The file should contains WiFi access point configuration options and values, which should be defined as <b>option: value</b> (for example, <i>ssid: home_wifi</i>). The SSID option is mandatory.

[[File:Networking_rutos_manual_wireless_multi_ap_access_points.png|border|class=tlt-border]]

[[File:Networking_rutos_manual_wireless_multi_ap_access_points_v1.png|border|class=tlt-border]]

<table class="nd-mantable">

<table class="nd-mantable">