0
edits
Changes
Template:Networking rutxxx configuration example JSON RPC linux (view source)
Revision as of 18:04, 13 April 2020
, 18:04, 13 April 2020→Using JSON-RPC with Linux OS
==Introduction==
{{Template:Networking_rutxxx_manual_fw_disclosure | fw_version= {{{fw_version}}} }}
'''JSON-RPC''' is a remote procedure call protocol encoded in JSON. It is a very simple protocol (and very similar to XML-RPC), defining only a few data types and commands. JSON-RPC allows for notifications (data sent to the server that does not require a response) and for multiple calls to be sent to the server which may be answered out of order.
This article provides a guide on how to use JSON-RPC on RUTxxx routers.
==Configuration overview and prerequisites==
Before we begin, let's overview the configuration that we are attempting to achieve and the prerequisites that make it possible.<br>
'''Prerequisites''':
* A PC for with a HTTP request software.
* An Internet connection. (''This example is based in a local configuration, but also can be used via wired WAN or a remote installation with Public IP'')
* One RUTxxx series router.<br>
'''Configuration scheme:'''
[[File:{{{file_scheme}}}|border|class=tlt-border|center]]
==Enabling JSON-RPC==
Before anything else, you'll need to make sure JSON-RPC is enabled on your router. JSON-RPC is enabled by default, so if you haven't made any changes to the router's access settings, everything should be in order. Otherwise you can check JSON-RPC status by logging into your router's WebUI and navigating to '''System → Administration → Access Control'''. Look for the ''WebUI'' section; there will be an '''Enable JSON RPC''' field. Make sure it is checked:
[[File:WEBUI JSON.jpg|border|class=tlt-border|center]]
==Using JSON-RPC with Linux OS==
==Using JSON-RPC with Linux OS==
