Difference between revisions of "Template:Networking tsw1xx manual powering options"
From Teltonika Networks Wiki
Gytispieze (talk | contribs) |
Justas.Cip (talk | contribs) |
||
| Line 20: | Line 20: | ||
<b>{{{name}}} Batch 001 onwards:</b> use UTP (Unshielded) cable only when connecting non-Active PoE (non-803.3af/at) equipment or make sure that these devices support voltages, provided by TSW100 PSU. | <b>{{{name}}} Batch 001 onwards:</b> use UTP (Unshielded) cable only when connecting non-Active PoE (non-803.3af/at) equipment or make sure that these devices support voltages, provided by TSW100 PSU. | ||
| TSW101 = | | TSW101 = | ||
| + | }} | ||
| + | |||
| + | {{#switch:{{{name}}} | ||
| + | | TSW100|TSW101= ==Disclaimer: {{{name}}} and Passive PoE devices== | ||
| + | |||
| + | There are a couple of options to stay safe when using {{{name}}} '''Active PoE''' with devices that only support '''Passive PoE''': | ||
| + | |||
| + | * Connect {{{name}}} and Passive PoE device only via non-PoE Ethernet ports (for example, '''do not''' use {{{name}}} PoE ports with '''LAN1''' ports on Teltonika devices). | ||
| + | * If there is a need to use '''LAN1''' port on the end device, make sure that {{{name}}} and the end device are '''powered from different voltage sources''' (for example, power both devices from different PSUs, or different batteries). | ||
| + | |||
}} | }} | ||
[[Category:{{{name}}} Manual]] | [[Category:{{{name}}} Manual]] | ||
Revision as of 17:08, 28 November 2022
This chapter contains information on powering options supported by {{{name}}} switch.
The switch has a pin power socket and can be powered by a VDC power supply unit (PSU). Refer to the image below for the power socket's pinout information:
Power socket
{{Template: Networking_{{{series}}}_manual_power_socket_pinout | name = {{{name}}} }}
[[Category:{{{name}}} Manual]]
