Difference between revisions of "Wireless Mesh configuration example"
From Teltonika Networks Wiki
| Line 12: | Line 12: | ||
<li>Access router‘s WebUI. Navigate to '''Network''' -> '''Interfaces'''.</li> | <li>Access router‘s WebUI. Navigate to '''Network''' -> '''Interfaces'''.</li> | ||
<li>Press the pencil icon on the right of the LAN interface.</li> | <li>Press the pencil icon on the right of the LAN interface.</li> | ||
| + | <li>If necessary, select Protocol in the General settings tab as Static. </li> | ||
| + | <li>Enter IPv4 address, as well as subnet mask. </li> | ||
| + | <li>Enable DHCP. Based on your requirements, edit DHCP limit and lease time or leave the rest of the settings as set by default. </li> | ||
| + | <li></li> | ||
</ol> | </ol> | ||
Revision as of 17:04, 16 March 2022
Introduction
Prerequisites
The configuration of wireless mesh with Teltonika devices is relatively simple and involves only a few steps repeated for multiple devices. The device count depends on the use case, however, the configuration provided can be easily scaled for many devices. For the following example, three RUTX11 routers will be used:
- One router will needs to have an internet access. It will act as a mesh gateway and DHCP server.
- Other routers will operate as mesh nodes.
Configuration
Mesh gateway
This router must have access to the internet. The following settings should be enabled by default.
- Access router‘s WebUI. Navigate to Network -> Interfaces.
- Press the pencil icon on the right of the LAN interface.
- If necessary, select Protocol in the General settings tab as Static.
- Enter IPv4 address, as well as subnet mask.
- Enable DHCP. Based on your requirements, edit DHCP limit and lease time or leave the rest of the settings as set by default.
