Difference between revisions of "Serial Interface Control Commands"
From Teltonika Networks Wiki
(6 intermediate revisions by 3 users not shown) | |||
Line 1: | Line 1: | ||
+ | __TOC__ | ||
+ | |||
== Serial Interface Control Commands == | == Serial Interface Control Commands == | ||
− | |||
− | |||
The command controls the behavior of the UE‟s DCD (data carrier detection) line. | The command controls the behavior of the UE‟s DCD (data carrier detection) line. | ||
− | + | [https://wiki.teltonika-networks.com/wikibase/images/2/2e/Quectel_EC25EC21_AT_Commands_Manual_V1.2.pdf#page=32 '''3.1. AT&C Set DCD Function Mode - page 31'''] | |
− | + | ||
The commanddetermines how the UE responds if DTR line is changed from lowto highlevelduring data mode. | The commanddetermines how the UE responds if DTR line is changed from lowto highlevelduring data mode. | ||
− | + | [https://wiki.teltonika-networks.com/wikibase/images/2/2e/Quectel_EC25EC21_AT_Commands_Manual_V1.2.pdf#page=32 '''3.2. AT&D Set DTR Function Mode - page 31'''] | |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− |
Revision as of 10:58, 22 November 2019
TRM240 AT Commands > TRM240 AT Commands > TRM240 AT Commands > TRM240 AT Commands > TRM240 AT Commands > TRM240 AT Commands > TRM240 AT Commands > TRM240 AT Commands > TRM240 AT Commands > TRM240 AT Commands > Serial Interface Control CommandsSerial Interface Control Commands
The command controls the behavior of the UE‟s DCD (data carrier detection) line.
3.1. AT&C Set DCD Function Mode - page 31
The commanddetermines how the UE responds if DTR line is changed from lowto highlevelduring data mode.