Difference between revisions of "How to enable remote access for RMS on the router?"
From Teltonika Networks Wiki
(Created page with "To add a device to Teltonika's Remote Management System (RMS) '''remote monitoring for RMS''' must be enabled from the router's side. In order to do so, folow these steps: *...") |
|||
| Line 24: | Line 24: | ||
'''NOTE''': if you are adding more than one device, don't forget to do this for each separate device. | '''NOTE''': if you are adding more than one device, don't forget to do this for each separate device. | ||
| + | |||
| + | ==See also== | ||
| + | |||
| + | * [[How to add a new device to RMS?]] | ||
| + | * [[How to add multiple devices to RMS at once?]] | ||
Revision as of 11:31, 7 May 2018
Main Page > IoT Platforms > RMS > RMS FAQ > How to enable remote access for RMS on the router?To add a device to Teltonika's Remote Management System (RMS) remote monitoring for RMS must be enabled from the router's side. In order to do so, folow these steps:
- Open your web browser ant type in the router's LAN IP address (192.168.1.1 by default) into the URL field and press the "Enter" key:
- Next, you will be greeted with the Login window. Type in your login information and click "Login":
NOTE: default login values are Username: admin; Password: admin01 (this is the default password for RUT routers, but you will be prompted to change it during you first login. If this is not your first login, use the password you chose before).
- When you completed the login, navigate to the System menu and click on the Administration field:
- From the Administration Settings window go to the RMS section located near the top of the page:
- Place a check mark next to the "Enable remote monitoring" field"
NOTE: if you are adding more than one device, don't forget to do this for each separate device.
