Difference between revisions of "RUT850 Routing"

From Teltonika Networks Wiki
Line 85: Line 85:
[[Category:RUT850 WebUI]]
[[Category:RUT850 Network section]]

Latest revision as of 11:48, 7 May 2020

Main Page > RUT Routers > RUT850 > RUT850 Manual > RUT850 WebUI > RUT850 Network section > RUT850 Routing

Summary[edit | edit source]

This chapter is an overview of the Routing section in RUT devices.

Static Routes[edit | edit source]

Static routes specify over which interface and gateway a certain host or network can be reached. In this page you can configure your own custom routes.

Network routing static routes.PNG

field name value description
Routing table Main | WAN | WAN2 | WAN3; Default: WAN Defines which table will be used for the route in question
Interface LAN | WAN(wired) | WAN2(Mobile) | WAN3(WiFi) | VPN instances; Default: WAN(wired) The zone where the target network resides
Destination address* ip; Default: The address of the destination network
Netmask* ip; Default: A Mask that is applied to the Target to determine to what actual IP addresses the routing rule applies
Gateway ip; Default: " " Defines where the router should send all the traffic that applies to the rule
Metric integer; Default: 0 The Metric value is used as a sorting measure. If a packet about to be routed fits two rules, the one with the higher metric is applied

*Additional notes on Destination & Netmask:

You can define a rule that applies to a single IP like this: Destination - some IP; Netmask - Furthermore, you can define a rule that applies to a segment of IPs like this: Destination – some IP that STARTS some segment; Netmask – Netmask that defines how large the segment is. e.g.:

field name value description Only applies to Applies to IPs in the - - - -