RUT955 Inverting Relay Output Polarity

From Teltonika Networks Wiki
Revision as of 12:09, 12 June 2020 by Dziugas (talk | contribs) (Created page with "In some cases you might want to make RUT955's relay default state ''high''. The problem is that when you reboot the router the router's relay goes back to its default state ('...")

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)
Main Page > RUT Routers > RUT955 > RUT955 Hardware Application Examples > RUT955 Inverting Relay Output Polarity

In some cases you might want to make RUT955's relay default state high. The problem is that when you reboot the router the router's relay goes back to its default state (low) for a short period of time. In this case if you want to constantly keep it in high' state you could connect your load like shown in the picture below:

Inverting relay output.png

For further information about relay control refer to this page: http://wiki.teltonika-networks.com/index.php?title=Input/Output