Difference between revisions of "RUTXR1 LEDs"
From Teltonika Networks Wiki
m (Protected "RUTXR1 LEDs" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))) |
|||
Line 9: | Line 9: | ||
| power_leds = 2 <!-- number of power LEDs --> | | power_leds = 2 <!-- number of power LEDs --> | ||
| wan = 1 <!-- 1 has WAN type LEDs; 0 doesn't have WAN type LEDs --> | | wan = 1 <!-- 1 has WAN type LEDs; 0 doesn't have WAN type LEDs --> | ||
− | | wifi = | + | | wifi = 0 <!-- 1 has WiFi band LEDs; 0 doesn't have WiFi band LEDs --> |
}} | }} |
Revision as of 10:41, 31 August 2020
Main Page > RUTX Routers > RUTXR1 > RUTXR1 Manual > RUTXR1 LEDsThis page contains information the different types of LEDs and their behaviour on a RUTXR1 device.
Power LED
The power LED is located on the bottom left corner of the front panel, just under the power connector.
It indicates whether the device is powered on or not.
State | Description |
---|---|
M LED turned on | Device is powered over the Main power connector. |
M LED turned off | Device is not powered over the Main power connector.. |
R LED turned on | Device is powered over the Reserve power connector. |
R LED turned off | Device is not powered over the Reserve power connector. |
WAN type LEDs
The WAN type LEDs are located at the top-right of the front panel.
They indicate which type of Internet connection is currently active.
State | Description |
---|---|
SIM1 LED on | A mobile data connection on SIM1 is active. |
SIM1 LED off | A mobile data connection on SIM1 is inactive. |
SIM2 LED on | A mobile data connection on SIM2 is active. |
SIM2 LED off | A mobile data connection on SIM2 is inactive. |
ETH LED on | An Ethernet data connection (wired WAN) is active. |
ETH LED off | An Ethernet data connection (wired WAN) is inactive. |
Mobile network type LEDs
The mobile network type LEDs are located near the SIM card slot.
They display which type of Internet connection is currently active.
Action | Description |
---|---|
3G LED turned on | Device is connected to a 3G network. |
4G LED turned on | Device is connected to a 4G network. |
3G blinking | Device is connected to a 3G network but hasn't received an IP address. |
4G blinking | Device is connected to a 4G network but hasn't received an IP address. |
All LEDs blinking at the same time every 500 ms | No SIM card or incorrect PIN. |
All LEDs turn on and off in a sequence one after the other | The device is attempting to connect to a mobile network operator. |
Mobile signal strength indication LEDs
The mobile signal strength indication LEDs are located near the SIM card slot.
The number of lit up LEDs represents a different mobile signal strength (RSSI) value in dBm.
No. of lit up LEDs | Signal strength value |
---|---|
0 | ≤ -111 dBm |
1 | -110 dBm to -82 dBm |
2 | -81 dBm to -52 dBm |
3 | ≥ -51 dBm |