This page contains information the different types of LEDs and their behaviour on a RUTXR1 device.
The power LED is located on the bottom left corner of the front panel, just under the power connector.
It indicates whether the device is powered on or not.
|M LED turned on||Device is powered over the Main power connector.|
|M LED turned off||Device is not powered over the Main power connector..|
|R LED turned on||Device is powered over the Reserve power connector.|
|R LED turned off||Device is not powered over the Reserve power connector.|
WAN type LEDs
The WAN type LEDs are located at the top-right of the front panel.
They indicate which type of Internet connection is currently active.
|SIM1 LED on||A mobile data connection on SIM1 is active.|
|SIM1 LED off||A mobile data connection on SIM1 is inactive.|
|SIM2 LED on||A mobile data connection on SIM2 is active.|
|SIM2 LED off||A mobile data connection on SIM2 is inactive.|
|ETH LED on||An Ethernet data connection (wired WAN) is active.|
|ETH LED off||An Ethernet data connection (wired WAN) is inactive.|
Ethernet port LEDs
There are two LEDs located at the top of each Ethernet port.
They provide information on the current states of the Ethernet ports. Each port has two LEDs:
- Orange - 10/100 Mbps connection
- Green - 1000 Mbps connection
Below is an explanation on the behaviours of green and orange LEDs.
|LED on||A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred).|
|LED off||No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card)).|
|LED blinking||Connection established and data is being transferred over this port.|
Mobile network type LEDs
The mobile network type LEDs are located near the SIM card slot.
They display which type of Internet connection is currently active.
|3G LED turned on||Device is connected to a 3G network.|
|4G LED turned on||Device is connected to a 4G network.|
|3G blinking||Device is connected to a 3G network but hasn't received an IP address.|
|4G blinking||Device is connected to a 4G network but hasn't received an IP address.|
|3G & 4G LEDs blinking at the same time every 500 ms||No SIM card or incorrect PIN.|
|3G & 4G LEDs turns on and off in a sequence one after the other||The device is attempting to connect to a mobile network operator.|
Mobile signal strength indication LEDs
The mobile signal strength indication LEDs are located near the SIM card slot.
The number of lit up LEDs represents a different mobile signal strength (RSSI) value in dBm.
|No. of lit up LEDs||Signal strength value|
|0||≤ -111 dBm|
|1||-110 dBm to -82 dBm|
|2||-81 dBm to -52 dBm|
|3||≥ -51 dBm|