Setting up WAN as LAN

From Teltonika Networks Wiki

Introduction

This article provides a guide on how to configure WAN port as LAN. These configurations are specifically made for RutX devices.

Configuring WAN as LAN

  • First you want to make sure that you have ADVANCED mode enabled. This will allow you to choose from a larger variety of settings.

Networking rutx manual webui basic advanced mode.gif


  • After that navigate to Network > Interfaces

Network interface settings.png

  • Disable WAN interface

Interfaces disable wan.png


  • Next we will edit our LAN interface and navigate to Physical settings where we will add Interface item from the dropdown menu.

Physical settings of interface lan.png


  • Select Ethernet Adapter item, by default it's eth1

Ethernet adapter in lan interface.png


  • It should result in something like this.

Eth1 appears in lan interface.png


  • Once you're done with configurations above just save any changes you made. Now head to VLAN settings and check if WAN VLAN ID 1 is disabled, and ID 2 is untagged.

Vlan settings for wan as lan.png


At this point, WAN port should work as LAN. Go ahead and try to swap from your to current port to WAN, you should be able to ping the router.