TCR100 LEDs

Revision as of 13:19, 22 December 2021 by Gytispieze (talk | contribs) (Gytispieze moved page Draft:TCR100 LEDs to TCR100 LEDs without leaving a redirect)

(diff) ← Older revision | Approved revision (diff) | Latest revision (diff) | Newer revision → (diff)

This page contains information the different types of LEDs and their behaviour on a TCR100 device.

Ethernet port LEDs

There are two LEDs located at the top of each Ethernet port.

Networking tcr100 manual leds ethernet leds.png

They provide information on the current states of the Ethernet ports. Each port has two LEDs:

  • Orange - 10/100 Mbps connection
  • Green - 1000 Mbps connection

Below is an explanation on the behaviours of green and orange LEDs.

State Description
LED on A data connection on the port is operational (cable plugged in, end device visible, no data is being transferred).
LED off No data connection on the port is operational (no cable, bad cable or end device not visible for some other reason (such as damaged network card)).
LED blinking Connection established and data is being transferred over this port.

Mobile signal strength indication LEDs

The mobile signal strength indication LEDs are located at the top of the device (three increasing bars).

Networking tcr100 manual leds mobile signal strength leds.png

The number of lit up LEDs represents a different mobile signal strength (RSSI) value in dBm.

No. of lit up LEDs Signal strength value
0 ≤ -111 dBm
1 -110 dBm to -82 dBm
2 -81 dBm to -52 dBm
3 ≥ -51 dBm

Internet connection LED

Networking tcr100 manual leds wan led.png

Network status LED which indicates WAN connection.

State Description
LED is on The router has an internet connection.
LED is blinking internet connection has been lost.

WiFi indication LED

Networking tcr100 manual leds wifi led.png

Network status LED for WiFi indication.

State Description
LED on WiFi is enabled.
LED off WiFi is disabled.