Template:Networking rut manual upnp

From Teltonika Networks Wiki

Summary

UPnP allows clients in the local network to automatically configure the router. This chapter is a summary of the UPnP function in RUT routers

The information in this page is updated in accordance with the [[Media:{{{fw_version}}}_WEBUI.bin|{{{fw_version}}}]] firmware version.

Active UPnP Redirects

[[File:{{{file_redirects}}}|border|class=tlt-border]]

123

General Settings

[[File:{{{file_settings1}}}|border|class=tlt-border]]

field name value description
Enable yes | no; Default: no Toggles UPnP ON or OFF
Use secure mode yes | no; Default: yes Toggles Secure mode ON or OFF

Advanced Settings

[[File:{{{file_settings2}}}|border|class=tlt-border]]

field name value description
Use UPnP port mapping yes | no; Default: yes Toggles UPnP port napping ON or OFF
Use NAT-PMP port mapping yes | no; Default: yes Toggles NAT-PMP port mapping ON or OFF
Device UUID yes | no; Default: yes Specify Universal unique ID of the device


UPnP ACLs

ACLs specify which external ports may be redirected to which internal addresses and ports

[[File:{{{file_ACLs}}}|border|class=tlt-border]]

field name value description
Comment string; Default: Allow high ports Adds a comment to this rule
External ports integer [0..65535]] | range of integers [0-65535]; Default: 1024-65535 External port(s) which may be redirected. May be specified as a single port or a range of ports. To specify a range use a dash ('-') symbol between two integer numbers
Internal Addresses ip/integer [0..32]; Default: 0.0.0.0/0 Internal address to be redirect to
Internal ports integer [0..65535]] | range of integers [0-655355]; Default: 1024-65535 Internal port(s) to be redirect to May be specified as a single port or a range of ports. To specify a range use a dash ('-') symbol between two integer numbers
Action allow | deny; Default: allow Allows or forbids the UPnP service to open the specified port