Template:Networking rut manual upnp

From Teltonika Networks Wiki

Summary

UPnP allows clients in the local network to automatically configure the router. This chapter is a summary of the UPnP function in RUT routers

The information in this page is updated in accordance with the [[Media:{{{fw_version}}}_WEBUI.bin|{{{fw_version}}}]] firmware version.

Active UPnP Redirects

[[File:{{{file_redirects}}}|border|class=tlt-border]]

General Settings

[[File:{{{file_settings1}}}|border|class=tlt-border]]

field name value description
Enabled yes | no; default: no Turns the UPNP service on or off.
Enable secure mode yes | no; default: yes Allow adding forwards only to requesting IP addresses
Enable additional logging yes | no; default: no Puts extra debugging information into the system log
Downlink Default: 1024 Value in KByte/s, informational only
Uplink Default: 512 Value in KByte/s, informational only
Port Default: 5000 Port to listen for requests

Advanced Settings

[[File:{{{file_settings2}}}|border|class=tlt-border]]

field name value description
Report system instead of daemon uptime yes | no; default: no Use system uptime as UPnP uptime
Device UUID Default:
Announced serial number Default:
Announced model number Default:
Notify interval Default: 30
Clean rules threshold Default: 20
Clean rules interval Default: 600
Presentation URL Default: http://192.168.1.1/
UPnP lease file Default: /var/upnp.leases

UPnP ACLs

ACLs specify which external ports may be redirected to which internal addresses and ports

[[File:{{{file_ACLs}}}|border|class=tlt-border]]

field name value description
Comment Default: Allow high ports Adds a comment to this rule
External ports Default: 1024-65535 External port(s) which may be redirected. May be specified as a single port or a range of ports. To specify a range use a dash ('-') symbol between two integer numbers
Internal Addresses Default: 0.0.0.0/0 Internal address to be redirect to
Internal ports Default: 1024-65535 Internal port(s) to be redirect to May be specified as a single port or a range of ports. To specify a range use a dash ('-') symbol between two integer numbers
Action Default: allow Allows or forbids the UPnP service to open the specified port