Difference between revisions of "Template:Networking rutos manual leds"
From Teltonika Networks Wiki
| (One intermediate revision by the same user not shown) | |||
| Line 175: | Line 175: | ||
}}|}}{{#ifeq: {{{mobile}}} | 1 | <h2>Mobile network type LEDs</h2> | }}|}}{{#ifeq: {{{mobile}}} | 1 | <h2>Mobile network type LEDs</h2> | ||
| − | The <b>mobile network type LEDs</b> are located near the SIM card | + | The <b>mobile network type LEDs</b> are located near the SIM card slot. |
[[File:Networking_{{lc:{{{name}}}}}_manual_leds_mobile_network_type_leds.png]] | [[File:Networking_{{lc:{{{name}}}}}_manual_leds_mobile_network_type_leds.png]] | ||
| Line 185: | Line 185: | ||
<th width=500>Action</th> | <th width=500>Action</th> | ||
<th width=500>Description</th> | <th width=500>Description</th> | ||
| − | </tr> | + | </tr>{{#ifeq: {{{2g}}} | 1 | |
| + | <tr> | ||
| + | <td>2G LED turned on</td> | ||
| + | <td>Device is connected to a 2G network.</td> | ||
| + | </tr>|}} | ||
<tr> | <tr> | ||
<td>3G LED turned on</td> | <td>3G LED turned on</td> | ||
| Line 193: | Line 197: | ||
<td>4G LED turned on</td> | <td>4G LED turned on</td> | ||
<td>Device is connected to a 4G network.</td> | <td>Device is connected to a 4G network.</td> | ||
| − | </tr> | + | </tr>{{#ifeq: {{{2g}}} | 1 | |
| + | <tr> | ||
| + | <td>2G blinking</td> | ||
| + | <td>Device is connected to a 2G network but hasn't received an IP address.</td> | ||
| + | </tr>|}} | ||
<tr> | <tr> | ||
<td>3G blinking</td> | <td>3G blinking</td> | ||
| Line 203: | Line 211: | ||
</tr> | </tr> | ||
<tr> | <tr> | ||
| − | <td>3G & 4G LEDs blinking at the same time every 500 ms</td> | + | <td>{{#ifeq:{{{2g}}}|1|2G,|}} 3G & 4G LEDs blinking at the same time every 500 ms</td> |
<td>No SIM card or incorrect PIN.</td> | <td>No SIM card or incorrect PIN.</td> | ||
</tr> | </tr> | ||
<tr> | <tr> | ||
| − | <td>3G & 4G LEDs turns on and off in a sequence one after the other</td> | + | <td>{{#ifeq:{{{2g}}}|1|2G,|}} 3G & 4G LEDs turns on and off in a sequence one after the other</td> |
<td>The device is attempting to connect to a mobile network operator.</td> | <td>The device is attempting to connect to a mobile network operator.</td> | ||
</tr> | </tr> | ||
| Line 214: | Line 222: | ||
==Mobile signal strength indication LEDs== | ==Mobile signal strength indication LEDs== | ||
| − | The <b>mobile signal strength indication LEDs</b> are located near the SIM card | + | The <b>mobile signal strength indication LEDs</b> are located near the SIM card slot. |
[[File:Networking_{{lc:{{{name}}}}}_manual_leds_mobile_signal_strength_leds.png]] | [[File:Networking_{{lc:{{{name}}}}}_manual_leds_mobile_signal_strength_leds.png]] | ||
Revision as of 14:57, 31 August 2020
This page contains information the different types of LEDs and their behaviour on a {{{name}}} device.
Power LED
The power LED is located on the bottom left corner of the front panel, just under the power connector.
[[File:Networking_{{{name}}}_manual_leds_power_led.png]]
It indicates whether the device is powered on or not.
| State | Description |
|---|---|
| M LED turned on | Device is powered over the Main power connector. |
| M LED turned off | Device is not powered over the Main power connector.. |
| R LED turned on | Device is powered over the Reserve power connector. |
| R LED turned off | Device is not powered over the Reserve power connector. |
[[Category:{{{name}}} Manual]]
