Difference between revisions of "Template:Networking rutos manual modbus modbus tcp set parameters table"
From Teltonika Networks Wiki
Gytispieze (talk | contribs) |
|||
(One intermediate revision by the same user not shown) | |||
Line 9: | Line 9: | ||
<th width="150">register value</th> | <th width="150">register value</th> | ||
<th width="466">description</th> | <th width="466">description</th> | ||
+ | </tr> | ||
+ | <tr> | ||
+ | <td>Hostname</td> | ||
+ | <td>7</td> | ||
+ | <td>Hostname (in decimal form)</td> | ||
+ | <td>Changes hostname</td> | ||
+ | </tr> | ||
+ | <tr> | ||
+ | <td>Device name</td> | ||
+ | <td>71</td> | ||
+ | <td>Device name (in decimal form)</td> | ||
+ | <td>Changes device name</td> | ||
</tr> | </tr> | ||
{{#ifeq:{{{wifi}}}|1| | {{#ifeq:{{{wifi}}}|1| | ||
Line 68: | Line 80: | ||
</tr> | </tr> | ||
}} | }} | ||
− | | | + | |RUT9= |
+ | <tr> | ||
+ | <td> Switch PIN 4 state </td> | ||
+ | <td>325</td> | ||
+ | <td>1{{!}}0</td> | ||
+ | <td>Toggles PIN 4 ON or OFF, when output is selected</td> | ||
+ | </tr> | ||
+ | | #default = | ||
<tr> | <tr> | ||
<td> Switch PIN 3 state </td> | <td> Switch PIN 3 state </td> |
Revision as of 09:07, 27 October 2021
Set Parameters
The Modbus daemon can also set some device parameters.
value to set | register address | register value | description |
---|---|---|---|
Hostname | 7 | Hostname (in decimal form) | Changes hostname |
Device name | 71 | Device name (in decimal form) | Changes device name |
Reboot | 206 | 1 | Reboots the router |
Switch PIN 3 state | 324 | 1|0 | Toggles PIN 3 ON or OFF, when output is selected |
Switch PIN 4 state | 325 | 1|0 | Toggles PIN 4 ON or OFF, when output is selected |