Template:Rms manual management commands access

From Teltonika Networks Wiki

To configure device access go to the RMS web page, Left sidebar panel, (Management → Overview) and click on Overview submenu.

Move your mouse pointer to the Top control Actions menu and select Access (Actions → Access).

RMS-device-menu-left-sidebar-panel.jpg RMS-top-menu-actions-access.jpg

The Access function provides you with the possibility to set up remote HTTP access to devices that are connected to a device's LAN, provided that the device in question has been registered to RMS.

RMS-how-to-use-Access.gif


Instructions


  1. Make sure that the device for which you would like to set up remote access is physically connected to the router's LAN or WAN (depends on your configuration).
  2. Locate and select that router in the device table.
  3. Move your mouse pointer to the "Actions" menu and click Access.
  4. New pop-up window will open, click the plus sign Rms plus symbol.png to create a new row.
  5. Fill out the new row will appropriate data (look for example in the table below). When you're finished, click "Save".
  6. Enter a custom name for the device (for easier management purposes), the router's port through which you will be connecting, the device's LAN IP address, the device's destination port to which you will be connecting to and, if you wish, place checkmarks under "Access without RMS login" and "Use custom basic-auth".
  7. The next Actions status pop-up will display the status of your request. If update is successful you will get a message: LAN device(s) created successfully. in the Status column.
FIELD NAME VALUE DESCRIPTION
Name For example: RUT230 A custom name for the LAN device.
External port For example: 8647 The device’s port through which you will be connecting. Only required for devices that have older firmware versions and connect to RMS via VPN.
Destination IP For example: 192.168.1.2 The device’s LAN IP address.
Destination Port Default: unchecked The destination device's WebUI HTTP port.
Access without RMS login Default: 80 If this is checked, the login screen will be skipped when connecting to the destination device.



Rms commands access part 3 v1.png



Rms commands access part 4 v2.png


  • You can then find remote access links in the "Device access" widget. You can find this widget by clicking the "Device information" icon located under the "Actions" column in the Device table, next to the relevant device:

Rms commands access part 5 v1.png


  • You will be redirected to the device's "Information overview" page. By default, the "Device access" widget will be in the top-left of that page. Locate the device that wish to access and click the link next to it:

Rms commands access part 6 v1.png


  • The next step will be different for different configurations and devices. For this example, I used another RUTxxx router that was connected to the RMS device's LAN. Therefore, when I click the link, I am redirected to RUTxxx login page. If the connected device is not a RUTxxx router, you will probably be directed to that device's login page. Just enter the authentication information and login:

Rut login page configuration examples version.png


  • You can later delete device access entries by once again selecting the device and clicking "Access" from the Command submenu. Then click the minus (-) sign next to the entry that you would like to delete:

Rms commands access part 7 v1.png


  • The next pop-up will display the status of your request. The device will be deleted when you see "Device <device_name> deleted successfully" indication under the "Event" field. You can then close the pop-up:

Rms commands access part 8 v1.png