What ports are used by RMS?

From Teltonika Networks Wiki
Revision as of 09:22, 20 August 2021 by RytisB (talk | contribs)

Introduction

This article shows what default UDP and TCP ports are used by the Teltonika Networks RMS. For all or specific RMS functionalities to work, the device or devices must access the IPs and ports provided below.

RMS Management

RMS Management uses the following IP address: 18.196.62.30 and the ports provided in the table below. Both ports are required.

Protocol Port number
TCP 15009
TCP 15010


RMS Connect

RMS Connect uses the following IP address: 18.192.27.240 and the ports provided in the table below.

Protocol Port number Service
TCP 20022 Remote SSH
TCP 20080 Remote HTTP(S)
TCP 20100 Remote SFTP
TCP 20120 Remote Telnet
TCP 23389 Remote Desktop

Remote mobile devices


RMS Connect - Remote mobile devices uses the following IP address: 3.66.242.160.

RMS VPN

RMS VPN uses the following IP addresses: 3.69.106.81 and 3.65.167.143.


* Although these are currently used ports, it is recommended to unblock all ports on specified IP addresses.

In most cases, access to these IP addresses shall not be an issue as usually none of the outgoing traffic is blocked.

However, where ISP blocks all non-standard ports or the SIM card is in a Private APN network/setup, you will have to inquire your ISP to allow the mentioned IP and Ports to be made available.