View source for RUT240 LEDs

{{Template: leds_intro}} RUT240 router. The information applies for both Quectel and MeigLink modules used in Teltonika devices.
__TOC__
==Power LED==

The '''power LED''' is located on the bottom left corner of the front panel, just under the power connector:

[[File:Rut240 power led v2.png|300px]]

{{Template: rut_power_led_table}}

==Ethernet port LEDs==

The '''Ethernet port LEDs''' are located on the router's front panel, under each respective Ethernet port:

[[File:Rut240 ethernet port leds v2.png|300px]]

{{Template: rut_ethernet_port_led_table}}

<span style="color: #0054A6;">'''*'''</span>  The '''bootloader menu''' is a special router state from which certain upgrades can be performed. For more information on the bootloader menu, click [[Bootloader menu|here]]

==Connection status LEDs==

The '''connection status LEDs''' are located on the left side of the front panel, between the power connector and the signal strength indication LEDs:

[[File:Rut240 connection status led v2.png|300px]]

{{Template: rut240_connection_status_leds_table}}

==Signal strength LEDs==

The '''signal strength LEDs''' are located in the center of the front panel, to the right of the connection status LEDs:

[[File:Rut240 signal strength leds v2.png|300px]]

{{signal strength leds table}}
----
After the router gets powered up, all signal strength LEDs will turn ON and stay ON for about 40 seconds or until the router's modem registers on a network - after this, the LEDs will start displaying the router's current signal strength.

[[Category:RUT240 Manual]]