Jump to content

WireGuard Configuration Example: Difference between revisions

no edit summary
No edit summary
No edit summary
 
(2 intermediate revisions by 2 users not shown)
Line 6: Line 6:
This page will show you an example on how to configure a basic tunnel between WireGuard interface and its peers.
This page will show you an example on how to configure a basic tunnel between WireGuard interface and its peers.


<u><b>Note:</b> WireGuard is additional software that can be installed from the <b>Services → Package Manager</b> page</u> (in RUT9/RUT2 this page is located in <b>System → Package Manager</b>).
<u><b>Note:</b> WireGuard is additional software that can be installed from the <b>System → Package Manager</b> page.</u>


==Prerequisites==
==Prerequisites==
Line 13: Line 13:
<li>Two RUTOS devices (this example will be written with RUTX09 and TRB141 in particular)</li>
<li>Two RUTOS devices (this example will be written with RUTX09 and TRB141 in particular)</li>
<li>An end device to configure devices (PC, Laptop, Tablet or Smartphone)</li>
<li>An end device to configure devices (PC, Laptop, Tablet or Smartphone)</li>
<li>One end device must have <b>Public</b> IP address</li>
<li>One of the RUTOS devices must have <b>Public</b> IP address</li>


==End results==
==End results==