Difference between revisions of "RUT950 FCC"
(3 intermediate revisions by one other user not shown) | |||
Line 6: | Line 6: | ||
Grantee Code: <b>2AET4</b> | Grantee Code: <b>2AET4</b> | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
===AT&T, T-Mobile version=== | ===AT&T, T-Mobile version=== | ||
Line 30: | Line 14: | ||
{|style="margin: 0 auto;valign="left"" | {|style="margin: 0 auto;valign="left"" | ||
− | | [[File:Networking Rut950 certification fcc a doc page 1.png|thumb|left| | + | | [[File:Networking Rut950 certification fcc a doc page 1.png|thumb|left|210px|DoC, page 1 ([[Media:RUT950A FCC DoC official v0.1 signed.pdf|download pdf]])]] |
− | | [[File:Networking Rut950 certification fcc a doc page 2.png|thumb|left| | + | | [[File:Networking Rut950 certification fcc a doc page 2.png|thumb|left|211px|DoC, page 2 ([[Media:RUT950A FCC DoC official v0.1 signed.pdf|download pdf]])]] |
− | | [[File:Networking Rut950 certification fcc frant dts.png|thumb|left| | + | | [[File:Networking Rut950 certification fcc frant dts.png|thumb|left|217px|FCC Grant ([[Media:206CC19 GRANT DTS.pdf|download pdf]])]] |
− | | [[File:Networking Rut950 certification fcc frant jbp.png|thumb|left| | + | | [[File:Networking Rut950 certification fcc frant jbp.png|thumb|left|217px|FCC Grant ([[Media:206CC19 GRANT JBP.pdf|download pdf]])]] |
|} | |} | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
{{fcc links}} | {{fcc links}} |
Revision as of 17:03, 18 October 2019
Main Page > RUT Routers > RUT950 > RUT950 Certification & Approvals > RUT950 FCCThe FCC Declaration of Conformity or the FCC label or the FCC mark is a certification mark employed on electronic products manufactured or sold in the United States which certifies that the electromagnetic interference from the device is under limits approved by the Federal Communications Commission.
Description
The FCC label is found even on products sold outside the US territory, because they are either products manufactured in the US and had been exported, or they are also sold in the US. This makes the FCC label recognizable worldwide even to people to whom the name of the agency Federal Communications Commission is not familiar
The Federal Communications Commission established the regulations on electromagnetic interference under Part 15 of the FCC rules in 1975. After several amendments over the years, these regulation were reconstituted as the Declaration of Conformity and Certification procedures in 1998.
FCC Compliance
(15C) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference;
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
(15B) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC RF Exposure Information
This device complies with the relevant FCC RF radiation exposure limit set forth for an uncontrolled environment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter and must be installed to provide a separation distance of at least 20cm from all persons.
RUT950 FCC
Grantee Code: 2AET4
AT&T, T-Mobile version
FCC ID: 2AET4RUT950A
Product code: RUT950 J***** (AT&T, T-Mobile version)
![]() DoC, page 1 (download pdf) |
![]() DoC, page 2 (download pdf) |
![]() FCC Grant (download pdf) |
![]() FCC Grant (download pdf) |
External links
https://www.fcc.gov/engineering-technology/laboratory-division/general/equipment-authorization
Disclaimer:
Test reports that are referenced in declarations and certificates can be provided upon request. For the request to be approved, the recipient of the test reports should be a certification authority or certified test house. The recipients will be asked to sign a non-disclosure agreement (NDA).